Discuter:Le site officiel des astuces, des soluces, des tips et des cheat codes de tous vos jeux vidéo

Un article de WikiAstuces.fr.

(Redirigé depuis Discuter:Accueil)

How to program a garage door opener

Imagine that it is outside cold and are back home in a good dinner. Now comes the show spoiler. You take the garage door opener remote and do what is necessary so that the garage door is open. The door does not open and worse, should be out in the cold to open the garage door. You take the car, Park in the garage and then mark the distance. You realize that is low in the battery. Oh no! You can change the batteries, then on again, but it has been quite some time that you did it and are unsure about how to program it. This is what this text to continue to be treated!

A door opener for garage remote programming

A garage door opener is a motorized device for opening and closing of garage doors, as we all know. While some of them are controlled by switches on the wall of the garage themselves, there are some remote-controlled also. We will take care of its programming in relation to the first away match. The task is not too complicated and it can easily be done. Take a look at how.front porch designs for mobile homes

Step 1 - the origins of the distance First, you will need to find out where the antenna comes out of engine open garage doors. Then you will have to see where is the learn button, or a set of switches. Once you find that you have to remove the cover of the objective of the motor head. In case you can't find the antenna if there is a receiver mounted on the outside wall with antenna, with a removable lid.

Step 2 – programming of the implementation If you're programming the first party with the help of the learning function, press that button on the motor. There is no limit of time 30 seconds, once the light turns on and lights up permanently. Once this is done, the next thing is press the corresponding button on the remote control. Hold down the button and then stops once the engine starts blinking light instead of being stable.

Step 3 – change Opener Where yours is an opener of type switch, remove the cover of the motor unit or wall mounted Receiver, after seeing where the antenna. Expect to see 8, 9 or 12 switches that have 2 or 3 positions each.

Step 4 - location of switches Last, but not least, for programming a garage door opener, you will need to open the lid of the batteries of the remote control and look for switches. For example, "Open = off / closed = On". Set each switch remote control to the exact same position on the engine. You will need a small screwdriver or a ball point pen to move switches.

It is now! That is! Now you'll have to close the battery cover and then you will have to put to the test the opener. If the programming was successful and the game switches are already solved! But there is one thing, that even though this is the way the programming is done, if this doesn't work, may need to refer to a manual or see online. At the end of the day, the key to know how to program a garage door opener is to know what kind of remote you need before getting one. It will be useful if you have a rough idea of how it works!

Outils personnels
    Toutes les astuces, les trucs, les tips et les soluces sont sur wikiastuces.fr